Three ways to your furniture
You decide how to start. Every route ends with a complete configuration including all dimensions and a drawing, which you send to us with one click.
From the catalogue
Choose a standard product such as a work table, sink unit or wall shelf and adapt length, depth and height to your room.
Made to measure
Build it step by step yourself: worktop, base, sinks, drawer units, doors, side panels and back panel.
Upload a sketch
Upload a photo or PDF of your hand sketch. Dimensions and positions are read out and entered as a suggestion that you check and adjust.
Your configuration is non-binding. We check every enquiry personally and get back to you with a quote.
What you can configure
Our standard material is stainless steel 1.4301 (AISI 304) with a ground finish. Whatever the configurator does not cover, we still make: simply enquire directly about custom pieces.
Don’t want to wait?
Send us your dimensions, a sketch or a few photos via the enquiry form. We will get back to you quickly with a quote.
Send an enquiry
Enter dimensions, material and location in the form and attach photos or a sketch.
Prepare your measurements
Our checklist helps you measure your room correctly and think of all connections.
What we make from stainless steel
Questions about the configurator
When can I use the configurator?
We are working on it and will launch it soon. Until then, you can reach us via the enquiry form or by phone.
Is a configuration binding?
No. You send us a non-binding enquiry. We check the dimensions and design and get back to you with a quote.
Can I already send a sketch today?
Yes. Simply attach your sketch or photos to the enquiry form. A hand sketch from above with all dimensions is enough.
What if my furniture is not in the configurator?
Then enquire directly. We make every piece to measure, including special shapes with bevels, cut-outs or recesses.